Citel EXTender 3000 Guía de instalación descargar pdf (Pagina 11)

EXTender 6000 Quick Installation Guide 11

Parts provided with the EXTender

Table 2: Part Provided with the EXTender

Quantity Description

1 EXTender 6000

1 Power Cord

1 DB-25, RS-530 cable

1 DB-9 RS-232 cable

1 Cat 5 Ethernet Cable

- Mounting Hardware

2 Mounting Brackets

1 Quick Install Guide

Parts not provided with the EXTender

• Digital telephones and communication line cords are NOT supplied with this system.

Note: Use two-wire digital telephones only.

• Punchdown blocks necessary to interface between the RJ-21 connector and the remote telephones.

• 50 pin cable with male RJ-21 connectors to interface between the punchdown block and the

EXTender. (See Pin Out Assignments on page 14)

• Analog telephone line for local use, if you purchased an analog line card.

Note: The analog line card is not available outside North America.

Installation Considerations

• The system operates from 100-240 VAC, 50-60 Hz. Do not apply power to the unit until instructed to

in the installation procedures.

• Install the power supply and cabling away from high power/high RF noise devices such as computers,

fans, fluorescent ballast, or power supplies.

• Use good wiring practices. Do not run wires over fluorescent lights, computers, air conditioners, etc.,

as this can introduce noise to the modems.

• The distance from the telephones to the EXTender should NOT exceed 500 feet.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 42 43

Sin comentarios

Citel EXTender 3000 Guía de instalación Pagina 11